Panasonic TX-20LB30X, TX-20LB30A, TX-20LB30M manual Manual Tune via top panel, Access Manual Tune

Tuning

MANUAL TUNE

It is possible to retune individual programme positions:

Press the MENU button.

Move to choose SETUP.

Access SETUP.

Move to choose TUNING MENU.

Access TUNING MENU.

Move to choose MANUAL TUNE.

Access MANUAL TUNE.

Select the programme position to be tuned.

Press repeatedly until required station is found.

When the desired station is found, press the OK button to store. The programme position will flash.

Press the TV/AV button at any time to go back to watching TV.

MENU

OK

1 2 3

4 5 6

7 8 9

0

	TV
	Example: TX-20LB30M
	1
	CH 12
	PROGRAMME -/+	STORE
OK	SEARCH -/+
	RETURN	EXIT

MANUAL TUNE

TV/AV

MANUAL TUNE (via top panel)

It is also possible to use the control panel buttons on the top of the TV to tune individual programme positions:

Press F until TUNING MODE is reached.

Press –/ or +/ to access TUNING MODE.

Press F until MANUAL TUNE is reached.

Press –/ or +/ to access MANUAL TUNE.

STR F TV/AV

Press TV/AV to move between Change programme, Search

and Change sound system.

Example: TX-20LB30M

Press –/or +/ to change programme position or start search.	CH 12
	1
	5. 5MHz

When the desired station is found, press STR to store.

The programme position will flash.	-, +	: SEARCH
	MANUAL TUNE
Repeat above procedure to tune additional programme positions.	TV / AV	: MOVE CURSOR
	STR	: TO STORE
	F	: TO EXIT

Press F at any time to exit the TUNING MENU.

STR F - / + / TV / AV

Notes:

•If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the COLOUR SYS selection on page 12.

•After the MANUAL TUNE is finished, press the Programme Number up button to confirm the tuning condition for each Programme Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers. Please refer to the SKIP function on page 12.

•When using a VCR without video and audio input / output terminals, it is convenient to connect the aerial cable as indicated in the instruction manual of VCR and to set the designated channel to Programme No.“0”. In that case, perform MANUAL TUNE after setting the COLOUR SYS and SOUND SYS in advance. Further, in multi-system VCR, it is more convenient to set the designated channel to several Programme Numbers.

15