Tuning Channels
Manual Tune
Before Manual Tune, Channel Select and Regional System must already be set (Refer to page 19).
1 MANUAL TUNE
1 | Press to select the MANUAL TUNE. |
|
Press to access to the MANUAL TUNE.
2 | Press to select the desired Programme | |
Number. | ||
|
Press to select the higher or lower channel. Search Start.
TUNING MENU |
|
CH SELECT | POSITION |
SYS SELECT | JAPAN |
AUTO TUNE |
|
MANUAL TUNE | ACCESS |
SOUND SYS | 6. 0MHz |
COLOUR SYS | AUTO |
FINE TUNE |
|
SKIP | OFF |
29 |
|
CH 12 |
|
| PROGRAMME |
RETURN | SEARCH |
TV / AV - EXIT | |
| ‘STR’ |
MANUAL TUNE | |
When a station is found.
2
3
STR
When the desired station is found, press to store.
The tuning position is memorised.
TV/AV
Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
SOUND SYS
SET UP
Press to display the SETUP MENU.
Proceed to the TUNING MENU, and then to the SOUND SYS ( refer to page 26).
Adjust the Sound System ( refer to page 22 step 2 to 3).
Helpful Hint
(1)If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the “Colour System Selection” operation on page 26.
(2) | After the Manual tune is finished, under the normal viewing condition press this button to confirm |
| |
| the tuning condition for each Programme Number. If some Programme Numbers are unused (no |
| TV stations), it is possible to skip such Programme Numbers. Please refer to the Programme |
| Number Skip operation on page 25. |
(3)When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable as indicated in the instruction manual of VCR and to set the designated channel to programme No. “0”. In that case, perform manual tune after setting the colour system and sound system in advance. Further, in
23
