Toshiba B-8204-QM-R installation manual NOTE Retain the two black screws and front plate

3.2 Installing the Rotary Cutter Unit on the B-SX5T Series

Since the strip module is standard on the B-SX5T series, it is necessary to remove the rewinder guide plate, strip sensor, etc. before installing the cutter module.

1)Turn the power off and disconnect the power cord.

2)When the printer is used in the batch or strip mode: Remove the two black screws to detach the front plate.

Front Plate

Black Screws

NOTE: Retain the two black screws and front plate.

When the printer is used in the built-in rewinder mode:

Open the top cover, remove the two SMW-4x8 screws, and detach the rewinder guide plate from the

printer. SMW-4x8B Screw

Rewinder Guide Plate

SMW-4x8B Screw

3)Remove the four B-4x5 screws from the side panel (L).

4)Open the top cover and remove the three P-4x8 screws that secure the side panel (L). B-4x5 Screw

Side Panel (L)

Top Cover

B-4x5 Screw P-4x8 Screw

- 7 -