Toshiba B-8204-QM-R installation manual

SM-4 x 8 Screw

27) Fit the two tabs of the cutter drive unit into the notches, and then fix the cutter unit with the three SM-4x8 screws.

Tab

Notch

Cutter Unit

SM-4 x 8 Screw

NotchTab

28)Attach the cutter cover to the cutter unit with the two screws so that the tab of the cutter cover turns on the cutter cover open switch.

NOTES: 1. Be careful not to pinch the cutter harness by the cutter cover.

2. Make sure that the anti-static brush is protruding from the media outlet.

Cutter Cover

Anti-static

Brush

Media Outlet

Cutter Cover Open Switch

Cutter Cover

Tab

Screw

29) Close the print head block and ribbon shaft holder plate.

NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of the print head block or damage to the print head.

30)Reassemble the side panel (L) and close the top cover. Finally check the cutter operation.

-14 -