Toshiba B-8204-QM-R installation manual NOTE Retain the two black screws and front plate

Rotary Cutter Module

B-8204-QM-R Installation Manual

WARNING!

1.Follow all manual instructions. Failure to do so could create safety hazards such as fire or electrocution.

•Manual instructions must be followed when installing option kits or adding cables to avoid system failures and to insure proper performance and operation

•Failure to follow manual instructions or any unauthorized modifications, substitution or change to this product will void the limited product warranty.

2.Turn the power off and disconnect the power cord before installing the rotary cutter module.

3.Be careful not to injure your fingers when installing the swing cutter module.

4.Be careful not to pinch your fingers or hands with the covers.

1.APPLICABLE MODEL

This optional kit is the rotary cutter module, which is intended for the following models:

B-SX4T Series, B-SX5T Series

NOTE: When using the Rotary Cutter to the B-SX4T Series, be sure to install the Ribbon Saving Module (B-9904-R/R2-QM). Failure to do this may cause a paper jam or ribbon error.

2. PACKING LIST

All the following parts are supplied with the kit. Make sure you have all items shown below.

Cutter Unit (1 pc.)

Cutter Cover (1 pc.)

Cutter Drive Unit (1 pc.)

Harness Ass’y

(2-pin & 9-pin) (1 pc.)

Cord Bush (1 pc.) (For B-SX4 only)

Print Head Cleaner (1 pc.)

(P/No.: FMQB0051601)

•Installation Manual (1 copy)

•SM-4x8 Screw (6 pcs.)

3. INSTALLATION PROCEDURE

3.1 Installing the Rotary Cutter Unit on the B-SX4T Series

1)Turn the power off and disconnect the power cord.

2)Remove the two black screws to detach the front plate.

Front Plate

Black Screws

NOTE: Retain the two black screws and front plate.

- 1 -