18)Attach the cutter cover to the cutter unit with the two screws so that the tab of the cutter cover turns on the cutter cover open switch.
NOTES: 1. Be careful not to pinch the cutter harness by the cutter cover.
2.Make sure that the
Cutter Cover
Brush
Media Outlet 
Cutter Cover Open Switch
Cutter Cover
Tab
Screw
19) Close the print head block and ribbon shaft holder plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of the print head block or damage to the print head.
20) Reassemble the side panel (L) and close the top cover. Finally check the cutter operation.
- 6 -
