Panasonic TX-86PW300A, TX-76PW300A operating instructions Picture Menu, Normalisation N

Picture Menu

Push the PICTURE button.

Select the option.

Adjust the chosen option.

Push the TV/AV at any time to return to watching TV.

			Picture menu
			Menu
RF Mode			Contrast
			Colour
			Brightness
			Sharpness
			Colour Temperature	Standard
			P-NR	Auto
			Scan mode	75 / 833i
Picture menu
Menu
Contrast
Brightness		AV Mode
Sharpness
Colour
NTSC-Tint
Colour Temperature	Standard
P-NR	Auto
Scan mode	75 / 833i

MENU	The Viewing mode control allows you to change the Picture setting between Dy-
	namic, Normal and Cinema.
	Dynamic	For viewing in brightly lit rooms. This menu selects higher than normal
		levels of Brightness and Contrast.
	Normal	For viewing in normal (evening lighting) environments. This menu
		selects the normal levels of Brightness and Contrast.
	Cinema	For viewing in a dark room. This menu selects reduced levels of
		Brightness and Contrast.
Contrast
		Contrast
Brightness
Colour	Increase or decrease the level of these options to suit your personal preference.
Sharpness
Tint (AV only)
Colour temperature	The Colour temperature control allows you to change the White balance setting
	between Standard, Warm and Cool. .
P-NR	The P-NR (Picture Noise Reduction) system is designed to reduce picture noise
	during poor quality reception conditions. Pushing the left or right buttons will change
	the setting between Off, Strong, Weak and Auto.
Scan mode	The Scan mode control allows you to change the Picture refresh setting between
	75/883i, 100Hz and Progressive.
	The 75/883i mode gives a faster refresh rate and more lines than a standard
	television. 100Hz will give a steady picture for most signals. Progressive is
	recommended when receiving NTSC signals.
	NOTE: The scan mode function is not available when Picture in Picture is being

Notes:used.

1.You can change the level for each function (Contrast, Brightness, Colour, Sharpness and NTSC-Tint) for each picture menu option.

2.Picture menu levels can be set for TV, AV1, AV2, AV3, AV4 and AV5 modes.

3.NTSC-TINT only appears when the TV is receiving NTSC signals and the television is in the AV mode.

4.Only CONTRAST will be displayed in TELETEXT mode.

5.We recommend that you set the Scan mode to Progressive when viewing a PAL 60 or NTSC transmission. When viewing a PAL transmission (other than PAL 60) with the Scan mode set to Progressive, the screen will flicker. This is not a fault.

6.The Multipip function will not operate when a Progressive signal is used.

Normalisation N

Pressing the Normal ( ) Button on the remote control, will return all picture settings to the factory preset levels. This is called “Normalisation”.

Normalisation will only occur if the Picture Menu is not displayed when the Normal ( ) Button is pressed.

15