7
Installation

ACCESSORIES

Check the accessories before installations.
lOperating
Instruction book
lAC Power Cord lRemote Control
Unit
lBattery for the Remote
Control Unit
(2×AA (IEC R6) size)

Remote Control battery installation

1.Push the section marked with
an arrow while lifting the cover
up to open it.
Requires two AA batteries.
2.Install the batteries as shown in
the battery compartment.
(Polarity + or - must match the
markings in the compartment).
3.Close the cover by inserting the
top end first.

Precaution on battery use

Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.

Observe the following precautions:

1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline” ).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating this unit.

Helpful Hint:

Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend
that you record the code on page17-24, prior to setting up the remote.
Two AA size