Introduction and Installation

Note:

To open the case again, push the bottom of the front case, then release from the

rear case.

To attach the power cable

Sub Monitor station

DC terminal

Button

Button

Terminal

Terminalconnector connector

While pressing on the button hard with a pointed object such as a screwdriver, insert the power cable into the terminal connector.

To disconnect the power cable, press on the button hard while pulling out.

To attach an optional power cable, cut off about 12 mm (1/2) of the cable cover

(), then push in firmly until the end of the cable is securely inserted into the power connection terminal ().

Power cable cross section

Correct Incorrect

To attach the wires

Strip off of the wire cover so that about 9 mm (3/8) of the wire is exposed.

While pressing on the button with a pointed object such as a screwdriver, insert the wire into the terminal connector.

To disconnect a wire, press on the button while pulling out.

16

Page 16
Image 16
Panasonic VL-GM001 To attach the power cable Sub Monitor station DC terminal, Correct Incorrect To attach the wires