Panasonic WV-CLR920A, WV-CLR924AE operating instructions Editing the Setup Menu, Important Notices

• Editing the Setup Menu

Important Notices:

•When SET UP DISABLE appears in the bottom line of the SET UP menu, you cannot change the cur- rently active settings. This is to prevent accidental changing of the settings.

•Set the RS485 menu previously. (See page 25.)

•When the setup menu is closed after changing the parameters in the menu, the new values are saved in the EEPROM (Electric Erasable and Programmable Read Only Memory). These values remain valid until new values are saved, even if the power of the camera is off.

To edit the SET UP menu (change settings), press J and K or L and M to move the cursor to SET UP DISABLE in the bottom line.

Press I. SET UP DISABLE changes to SET UP ENABLE. Move the cursor to END, then to the item(s) you want to change. Move the cursor to CAMERA or RS485, then press I.

Refer to the following sections for a detailed description of menu items. If you decide not to make any changes after checking the current settings, move the cursor to RET in the bottom line, and press I to return to the SET UP menu. Then move the cursor to END in the SET UP menu, and press I to close the setup menu.

** SET UP **

CAMERA↵

RS485↵
END	SET UP DISABLE
** CAM SET UP **
CAMERA ID		OFF	↵
ALC/ELC		ALC	↵
SHUTTER		OFF
AGC		ON (DNR-H)↵
SENS UP		OFF
SYNC		INT
WHITE BAL		ATW1↵
MOTION DET		OFF
LENS DRIVE		DC

RET

** SET UP **

CAMERA↵

RS485↵
END		SET UP ENABLE
	* RS485		SET UP *
UNIT	NUMBER		1
BAUD	RATE		19200
DATA	BIT		8
PARITY CHECK			NONE
STOP	BIT		1
XON/XOFF			NOT USE
WAIT	TIME		OFF
ALARM DATA			AUTO2
DELAY TIME			OFF
RET

-24-