Panasonic WV-CLR920A, WV-CLR924AE operating instructions Electronic Sensitivity Enhancement Sens UP

ON (DNR-M):Applies AGC with middle-level DNR.

ON (DNR-L):Applies AGC with low-level DNR.

Notes:

•The higher the DNR level becomes, the more after images and the less noise you will see.

•Selecting DNR-L is recommended when the picture contains moving objects.

•When using a system controller, the parameters (DNR-H/M/L) will not appear on its setup menu.

2.Press I (set) to open the AGC MAX (maximum level) menu.

	** AGC MAX **
LEVEL	....I....
	-	+

RET END

3.Move the "I" cursor with L or M to adjust the AGC level.

4.Move the cursor to RET and press I to return to the CAM SET UP menu. When closing the menu, move the cursor to END and press I.

-34-

5.Electronic Sensitivity Enhancement (SENS UP)

There are two modes for SENS UP.

AUTO: If you select X32 AUTO, for example, the sensitivity is raised automatically to X32 max. When AUTO is selected, AGC is automatically set to ON.

FIX: If you select X64 FIX, for example, the sensitiv- ity is raised to just X64.

** CAM SET UP **

CAMERA ID	OFF	↵
ALC/ELC	ALC	↵
SHUTTER	OFF
AGC	ON(DNR-H)↵
SENS UP	OFF
SYNC	INT
WHITE BAL	ATW1 ↵
MOTION DET	OFF
LENS DRIVE	DC

RET

Move the cursor to SENS UP and select the parameter for electronic sensitivity enhancement.

The preset values for SENS UP (electronic sensitivity enhancement) change by pressing L or M as fol- lows:

OFFX2 AUTOX4 AUTOX6 AUTO X10 AUTO X16 AUTO X32 AUTO

X64 FIX X32 FIXX16 FIXX10 FIXX6 FIXX4 FIXX2 FIX OFF