• For using alarm input terminals 1-4
ALARM SETUP
ALARM DISPLAY ON
SITE ALARM ON
TERM.ALARM ON
ALARM OUTPUT 10S
ALARM BUZZER ON
ALARM TERMINAL
1.Display the ALARM SETUP menu.
2.Select ALARM TERMINAL by moving the joystick up or down.
3.Press the PRESET/SET/PROGRAM PRESET button. The ALARM TERMINAL screen appears as shown below.
ALARM TERMINAL
ALARM PRESET
1-
2-
3-
4-
4.Select the alarm terminal number by moving the joy- stick up or down.
5.Move the joystick to the right or left to select the desired preset numbers of the picture on the moni- tor in the range of
The initial factory setting is – (No assignment).
6.To return to the previous menu, press the HOME/ESC button.
Notes:
•ALARM TERMINAL is available only when a combi- nation camera is connected.
•If the camera has the Preset Alarm ON/OFF mode, set it to OFF.
■System Setup
1.Display the Setup menu.
2.Select SYSTEM SETUP by moving the joystick up or down.
3.Press the PRESET/SET/PROGRAM PRESET button.
The SYSTEM SETUP menu appears on the monitor as shown below.
SYSTEM SETUP |
|
|
CABLE COMP |
|
|
S | ||
SWITCH BUZZER | ON |
(1) Cable Compensation Setting
This item lets you select the cable length to compensate for transmission loss.
1.Display the SYSTEM SETUP menu.
2.Select CABLE COMP by moving the joystick up or down.
3.Select the most suitable cable length by moving the joy- stick to the right or left.
The initial factory setting is S.
S:Less than 400 m (1 300 ft)
M:400 m (1 300 ft) to 700 m (2 300 ft)
L:700 m (2 300 ft) to 900 m (3 000 ft)
(When using
(2)Switch Buzzer Setting
This item lets you select whether or not the switch buzzer sounds when a button is pressed.
1.Display the SYSTEM SETUP menu.
2.Select SWITCH BUZZER by moving the joystick up or down.
3.Select ON or OFF mode by moving the joystick to the right or left.
The initial factory setting is ON.
19