●Camera Patrol Learning for Camera Patrol Operation
The camera patrol learning function can be setup either from the Camera Setup menu or while operating the cam- era.
Follow the procedures below to setup the function for a connecting combination camera.
1.Press the PATROL PLAY/PATROL LEARN button within approx. 2 seconds while holding down the CAM- ERA SETUP/SETUP/PROGRAM button.
Note: Unless the PATROL PLAY/PATROL LEARN but- ton is pressed within approx. 2 seconds or more after holding down the CAMERA SETUP/SETUP/ PROGRAM button, the screen returns to the Setup menu of the
PATROL | CAMERA |
PLAY | SETUP |
| |
| SETUP |
PATROL LEARN | PROGRAM |
[LEARNING] appears on the monitor.
LEARNING
2.Run the camera through a patrol by using the joystick, zoom buttons etc. This combination camera will learn (memorize) the patrol. Maximum learning time is 30 seconds.
3.To stop the learning process, press the AUTO/B/W/ PATROL STOP button while holding down the CAM- ERA SETUP/ SETUP/PROGRAM button.
CAMERA | AUTO |
SETUP | |
SETUP | B/W |
PROGRAM | PATROL STOP |
[LEARNING] disappears from the monitor. Learning program
•Pan/Tilt (Joystick)
•Iris (Open/Close)
•Focus (Far/Near)
•Zoom (Tele/Wide)
•Preset Position
Note: The learning program differs depending on the camera. For further information, refer to the Operating Instructions for the camera to check the operations covered by the learning program before operating the camera.
●Preset Position Setting
Preset positions can be programmed either from the Camera Setup menu or from the System Controller.
The following functions are available with the respective functions.
1.Move the combination camera to the desired preset position by using the joystick.
UP
LR
DOWN
2.Press the numeric button for the preset position to be learned.
1 | 2 | 3 |
4 | 5 | 6 |
7 | 8 | 9 |
HOME | PRESET |
| 0 |
ESC |
| SET |
PROGRAM
PRESET
3.Press the PRESET/SET/PROGRAM PRESET button while holding down the CAMERA SETUP/SETUP/PRO- GRAM button.
| PRESET |
CAMERA |
|
SETUP |
|
SETUP | SET |
PROGRAM PROGRAM
PRESET
The actual camera position at the preset number pro- grammed in procedure 3 is learned as preset.
Preset data program
•Pan/Tilt (Joystick)
•Iris (Open/Close)
•Focus (Far/Near)
•Zoom (Tele/Wide)
Note: The preset data program differs depending on the camera. For further information, refer to the Operating Instructions for the camera to check the operations covered by the preset data program before operating the camera.
31
