Q-Logic SN0054621-00 E manual Sbootcodecid, Sdmrc, Sreset, Stadd

A

5– Non-Interactive Mode Commands Non-interactive Commands

-sbootcode

(Set Secondary Boot Target Information)

To set the secondary boot target and LUN, enter the -sbootcodecommand as follows:

-sbootcode<hba_port_inst> <Boot Target> <Boot LUN>

Issuing this command saves the configuration data to an XML file portable to all platforms supported by iSCSI. This command is not active for PPC.

For information on the interactive version of this command, see “Set Secondary Boot Target Information (CLI Option -sbootcode)” on page 4-35.

For primary boot code, see “-pbootcode (Set Primary Boot Target Information)” on page 5-24.

-sbootcodecid

(Set Alternative Client ID)

To set the alternative client ID (seven characters maximum), enter the -sbootcodecidcommand as follows:

-sbootcodecid<hba_port_inst> <Alternative Client ID>

This command is not active for the Power PC (PPC).

For information on the interactive version of this command, see “Set Alternative Client ID (CLI Option -sbootcodecid)” on page 4-36.

-sdmrc

To return the SDM library return code, enter the -sdmrccommand as follows:

-sdmrc [Simple_Pattern]

When [simple pattern] is given, only the lines containing that string are printed.

There is no corresponding interactive command for this function.

-sreset

(Reset Statistics)

To reset statistics to zero and count from this point forward, enter the -sresetcommand.

-stadd

To add a send target for discovery, enter the -staddcommand as follows:

-stadd <hba_port_inst> <ip address> [chapIndex] [<TGBCA> <value>]

Where <value> can be on or off; on causes the send target login to require bi-directional CHAP.

SN0054621-00 E 5-29