Q-Logic SN0054621-00 E manual Netconf6, Where option includes the following

5– Non-Interactive Mode Commands Non-interactive Commands

S

-netconf6

(Configure IPv6 Settings)

To manually configure the IPv6 network settings, enter the -netconf6command as follows:

-netconf6<hba_port_inst> [-IP <IPv6 Address>] [-IPNM <Subnet Mask><IPv6>] [-IPGW <Gateway Address>]

Where [option] includes the following:

IP <IP Address>	= Sets the IP address of the HBA.
-IPNM <Subnet	= Sets the subnet mask of the HBA.
Mask>
-IPGW <Gateway	= Sets the gateway.
Address>
-DISN4	= Disables IPv4 network setup a
-IPV4DHCP	= Set DHCP ON b
-IP	= Set IP Address
-IPNM	= Set IP Netmask
-IPGW	= Set IP Gateway
-DISN6	= Disable IPv6 Network Setup c
-IPLLA	= Set Local link Address Automatically d
-IPLL	= Set Local link Address Manuallyd
-IPR01A	= Set IPR0 and IPR1 Automatically e
-IPR0	= Set Routable Address 0 Manuallye
-IPR1	= Set Routable Address 1 Manuallye
-IPRRA	= Set Router Address Automatically f
-IPRR	= Set Router Address Manuallyf
Table Footnotes

aMutually exclusive with the other IPv4 commands

bMutually exclusive with -IP/-IPNM/IPGW

cMutually exclusive with -IPLLA/-IPLL

dManual or automatic—mutually exclusive

eManual or automatic—mutually exclusive

fManual or automatic—mutually exclusive

Setting the IP address, subnet mask, or gateway turns off DHCP address resolution for the IP configuration, if it is on. Some examples of usage follow.

5-22 SN0054621-00 E