Q-Logic SN0054621-00 E manual Linkchap, Model, HBA Parameters, Afwac

A

5– Non-Interactive Mode Commands Non-interactive Commands

-linkchap

(Assign a CHAP Entry to a Target)

To link a CHAP entry to a target, enter the -linkchapcommand as follows:

-linkchap <hba_port_inst> <CHAP No.> <Target ID>

This command does not reset the HBA.

For information on the interactive version of this command “Assign a CHAP Entry to a Target (CLI Option -linkchap)” on page 4-42.

-lp

The IPv6 local prefix list is created based on prefix information from router advertisements. Destination IP addresses containing these prefixes can be reached directly, without going through an intermediate router.

To display the local prefix list, enter the -lpcommand as follows:

-lp <hba_port_inst>

There is no corresponding interactive mode option for this command.

-model

To view the HBA “model(s)” (board type[s]) in the system, enter the -modelcommand as follows:

-model

There is no corresponding interactive mode option for this command.

-n

(Configure iSCSI Settings)

To set to HBA iSCSI parameters for single port HBAs, enter the -ncommand as follows:

-n <HBA No.> <Config NameConfig Alias> <Value> [<Config NameConfig Alias> <Value> …]

After you issue this command, the HBA is reset.

You can repeat the <Config NameConfig Alias> <Value> parameter set for as many parameters as you want to configure. Table 5-3lists these parameters and their ranges of values.

Table 5-3. HBA Parameters

Configuration Name

Configuration Alias

Value

Add Firmware Options

AFW_AutoConnect

AFWAC

on or off

SN0054621-00 E 5-19