Q-Logic SN0054621-00 E manual Display Program Version Information

A

5– Non-Interactive Mode Commands Non-interactive Commands

-t <hba_port_inst> [Target ID]

If you only specify the <hba_port_inst> parameter, SANsurfer iSCSI HBA CLI displays target information for all targets on the specified HBA port. If you specify the optional parameter [Target ID], SANsurfer iSCSI HBA CLI displays information on the specified target only. This includes both persistent and dynamic targets.

For information on the interactive version of this command, see “Display Target Information (CLI Option -t)” on page 4-37.

-tc

(Configure Target Parameters)

To set target parameter settings, use the -tccommand. For a list of target parameters you can configure, enter the following:

-tc<hba_port_inst> < Target_ID > <config_name config_alias> <value> <config_name config_alias> <value>

For information on the interactive version of this command, see “Configure Target Parameters (CLI Option -tc)” on page 4-39.

-tp

To see information stored in Flash memory about persistent targets, enter the -tpcommand. If you enter only the HBA port instance number, SANsurfer iSCSI HBA CLI returns information for all targets of that HBA port instance. If you enter the optional Target ID, SANsurfer iSCSI HBA CLI returns information for that target only, for example:

-tc <hba_port_inst> <Target_ID>

There is no corresponding interactive command for this function.

For a list of target parameters, see Appendix C Target Parameters.

-ts

To see summary information about both persistent and non-persistent targets, enter the -tscommand as follows:

-ts [hba_port_inst] [Target_ID]

There is no corresponding interactive command for this function.

-ver

(Display Program Version Information)

To view the SANsurfer iSCSI HBA CLI program version, enter the -vercommand as follows:

SN0054621-00 E 5-31