Q-Logic SN0054621-00 E manual Port Restore Factory Defaults, Configure IPv6 TCP Settings

4 – Interactive Mode Commands Port Level Info & Operations Menu

S

IPv6_Port [3260] :_

IPv6_Gratuitious_Neighbor_Ad_Enable [off] :_

IPv6_Redirect_Enable [off] :_

Configure IPv6 TCP Settings

Select the Configure IPv6 TCP Settings option to view each current IPv6 TCP setting and, optionally, changing a setting. For example:

IPv6_Nagle [off] :_

IPv6_TCP_Time_Stamp [on] :_

Legacy QLA4010 Restore Default Port Settings

Select the Legacy QLA4010 Restore Default Port Settings option to reinstate default port settings to any QLA4010 HBAs in the system. When you enter this option, the following warning appears:

Warning: This function is resetting the firmware to its default configuration. These changes will not become permanent until the HBA settings are saved.

Press the enter key to continue.

Port Restore Factory Defaults

(CLI Option -rdh)

NOTE:

This option is not supported in the QLA4010 HBA.

Use the Port Restore Factory Defaults option to reset the firmware for a single port to the factory default values. Be sure to select both Save changes and reset HBA and then Refresh afterwards; otherwise, the changes will not take effect.

This option updates the HBA factory default settings for the following HBA modules:

„Firmware parameters

„Network settings (IP, netmask, and so on)

„iSCSI name

„Target settings

„CHAP settings

„NVRAM settings

„IPsec settings

After selecting this option, you are asked if you want to restore all of the factory defaults in the preceding list. Do one of the following:

4-28 SN0054621-00 E