Q-Logic SN0054621-00 E manual Port Network Settings Menu, Display Configured Link Configuration

4 – Interactive Mode Commands Port Level Info & Operations Menu

Display Configured Link Configuration

(CLI Option -lcd)

S

Select the Display Configured Link Configuration option to view the following information about the configured link:

Portal Flow Control : (on or off)

Auto-negotiate link speed: (on or off)

Link Speed : (in Mbs)

Configure Link Configuration

(CLI Option -lc)

Select the Configure Link Configuration option to view and modify each of the configurable link settings, including:

„Auto-negotiate link speed

„Flow Control

The current setting (on or off) is shown in brackets. To change a setting, type on or off, and then press ENTER.

Save Changes and Reset HBA (if necessary)

Before resetting the HBA, ensure no connections are active. Select the Save Changes and Reset HBA option to save your changes and reset all ports on the HBA.

Port Network Settings Menu

The Port Network Settings Menu options include the following:

1.Display Network Settings (see page 4-20)

2.Configure IP Settings (see page 4-21)

3.iSNS Settings (see page 4-21)

4.Select HBA Port (see page 4-49)

5.Save Changes and Reset HBA (see page 4-18)

6.Refresh (see page 4-49)

7.Exit (see page 4-50)

Display Network Settings

(CLI Options -netconf)

Select the Display Network Settings option to view the settings for dynamic host configuration protocol (DHCP), link local address, IPv6, and iSNS. For example:

Using DHCP to obtain an IP Addresses.

IPv4 Address	: 10.14.65.19
Gateway	: 10.14.64.1
Subnet Mask	: 255.255.254.0

4-20 SN0054621-00 E