Q-Logic SN0054621-00 E manual

A

SANsurfer iSCSI HBA CLI User’s Guide Command Line Interface for QLogic iSCSI Host Bus Adapters

-dr(Display Default Router List [IPv6 only])	5-8
-dspchap (Display a CHAP Table)	5-9
-dtdsp (Display Discovered Targets)	5-9
-dtdspa (List Targets)	5-9
-dtdupd (Duplicate a Discovered Target)	5-9
-dtdupd (Duplicate a Persistent Target)	5-10
-dtli (Login and Persist a Discovered Target)	5-10
-dtlia (Login and Persist a Discovered Target)	5-10
-dtrem (Remove Discovered Target)	5-10
-dtrema (Remove Discovered Target)	5-11
-dumpcore(Retrieve FW Coredump Record)	5-11
-dumpnvram(Retrieve FW Flash & NVRAM Record)	5-11
-dv	5-11
-edchap (Edit a CHAP Entry)	5-11
-ei)	5-12
-f (Update Firmware Image—Specific HBA)	5-12
-fa (Update Firmware Image—All HBAs)	5-12
-g (Display General System Information)	5-13
-gcr (Retrieve FW Crash Record)	5-13
-h (Help)	5-13
-i (List All QLogic iSCSI HBA Ports Detected)	5-14
-import (Import HBA Configuration)	5-15
-ipdhcp (Configure IP Settings)	5-16
-isns(Configure iSNS Settings)	5-16
-isns6(iSNS Settings)	5-17
-l (List LUN Information)	5-17
-lb (Perform Loopback Test)	5-18
-lc (Configure Link Configuration)	5-18
-lcd (Display Configured Link Configuration)	5-18
-linkchap (Assign a CHAP Entry to a Target)	5-19
-lp	5-19
-model	5-19
-n (Configure iSCSI Settings)	5-19
-nc (Display Neighbor Cache)	5-21
-netconf (Configure IPv6 Settings)	5-21
-netconf6 (Configure IPv6 Settings)	5-22
-nh (Configure iSCSI Settings)	5-23
-pa (Add a Target)	5-23
-pad	5-24

SN0054621-00 E Page ix