Q-Logic SN0054621-00 E manual HBA Information, For IBM cards, the following modes are available

A

5– Non-Interactive Mode Commands Non-interactive Commands

Where:

1= Disabled

2= Manual mode

3= DHCP–Root path

If HBA DHCP is enabled (see “-ipdhcp (Configure IP Settings)” on page 5-16), modes 1–3 are allowed. If HBA DHCP is not enabled, bootcode DHCP is not allowed. This mode is not supported for QLA4010 HBAs. This mode is not active for the PPC.

For IBM cards, the following modes are available:

4= DHCP Vendor ID

5= DHCP-Auto

6= Auto

7= System Mode

For information on the interactive version of this command, see “Set BIOS/UEFI [or FCode] Mode (CLI Option -bootcodemode)” on page 4-35.

NOTE:

Bootcode DHCP is not allowed for QLA4010 HBAs.

-c

(Display Configured Port Settings)

To view the configured settings for the port, enter the -ccommand as follows:

-c [hba_port_inst]

When you specify a port instance, information for only that HBA is shown. When you do not specify a port instance, information for all HBA ports in the system is shown.

For a list of HBA settings, see “Display Configured Port Settings (CLI Option -c)” on page 4-22and Appendix C Target Parameters.

-ch

(HBA Information)

To display the HBA’s configured settings, enter the -chcommand as follows:

-ch [hba_port_inst]

When you specify a port instance, information for only that HBA is shown. When you do not specify a port instance, information for all HBA ports in the system is shown.

SN0054621-00 E 5-5