Q-Logic SN0054621-00 E manual Netconf, Display Neighbor Cache

A

5– Non-Interactive Mode Commands Non-interactive Commands

Table 5-3. HBA Parameters (Continued)

Configuration Name	Configuration Alias	Value
KeepAliveTO	KATO	0–65535
Large_Frames	LRGFRM	on or off a
MaxBurstLen	MBL	0–65535
MaxOutstandingR2T	MOR2T	0–65535

aNot for QLA4010

For information on the interactive version of this command, see “Configure iSCSI Settings (CLI Options -n and -nh)” on page 4-24.

-nc

(Display Neighbor Cache)

To display the neighbor cache (IPv6 only), enter the -nccommand as follows:

-nc <hba_port_inst>

For information on the interactive version of this command, see “Display Neighbor Cache (IPv6) (CLI Option -nc)” on page 4-33.

-netconf

(Configure IPv6 Settings)

To configure the network settings, enter the -netconfcommand as follows:

-netconf<hba_port_inst> [-IP <IP Address>] [-IPNM <Subnet Mask>] [-IPGW <Gateway IP Address>]

Where:

IP <IP Address>	= Sets the IP address of the HBA.
IPNM <Subnet Mask>	= Sets the subnet mask of the HBA.
-IPGW <Gateway Address>	= Sets the gateway.
-DISN4	= Disables IPv4 network setup.
-IPv4DHCP	= Sets DHCP on.

Setting the IP address, subnet mask, or gateway turns off DHCP address resolution for the IP configuration, if it is on.

For information on the interactive version of this command, see “Configure IPv6 Settings (CLI Options -netconf,-netconf6,-isns,-isns6,-ip, and -nc)” on

page 4-27.

SN0054621-00 E 5-21