Q-Logic SN0054621-00 E manual Ipdhcp, Isns, Configure iSNS Settings

5– Non-Interactive Mode Commands Non-interactive Commands

S

I= Configure the iSCSI name. T = Configure the targets.

C = Configure the CHAP table.

B= Configure the boot parameters. (only valid when T [tar- gets] parameter is also specified).

Filename = The XML file with the HBA configuration. See “-save (Save Host Configuration)” on page 5-28).

For information on the interactive version of this command, see “Import HBA Configuration (CLI Option -import)” on page 4-10.

-ipdhcp

(Configure IP Settings)

To set the HBA to get its IP address, subnet mask, and gateway from the DHCP server, enter the -ipdhcpcommand as follows:

-ipdhcp<hba_port_inst> [-option]

If the HBA port had prior values set manually, the DHCP values replace them. Where [option] includes:

-DISN4= Disable IPv4 network -IPV4DHCP= Set DHCP ON

-IP= Set IP Address

-IPNM= Set IP Netmask

-IPGW= Set IP Gateway

-DISN6= Disable IPv6 Network Setup

-IPLLA= Set Local link Address Automatically -IPLL= Set Local link Address Manually -IPRA= Set IPR0 and IPR1 Automatically -IPR0= Set Routable Address 0 Manually -IPR1= Set Routable Address 1 Manually

-IPRAA= Set Router Address Automatically -IPRR= Set Router Address Manually

For information on the interactive version of this command, see “Configure IP Settings (CLI Option -ipdhcp)” on page 4-21.

-isns

(Configure iSNS Settings)

To configure the iSNS settings for QLA4010 and QLA405x, enter the -isnscommand as follows:

5-16 SN0054621-00 E