Q-Logic SN0054621-00 E manual Configure Firmware Settings, Configure Device Settings

A

4 – Interactive Mode Commands Port Level Info & Operations Menu

Each setting is displayed with the current value in brackets, for example:

iSCSI_Snack [off] :

To change the value, type the new value after the prompt. To keep the current value, press ENTER at the prompt. The next iSCSI setting appears. The settings are shown one by one, in the order shown in the preceding list.

Table A-1 on page A-1describes these settings.

Configure Firmware Settings

Use the Configure Firmware Settings option to modify the following firmware settings:

„FW_ZIO_Enable_Mode

„AFW_Device_Timeout

„AFW_Delayed_Ack

„AFW_AutoConnect

Each setting is displayed with the current value in brackets, for example:

AFW_Device_Timeout [on] :

To change the value, type the new value after the prompt. To keep the current value, press ENTER at the prompt. The next firmware setting appears. The settings are displayed one-by-one, in the order shown in the preceding list.

Table A-1 on page A-1describes these settings.

Configure Device Settings

Select the Configure Device Settings option to modify the following device settings:

„Large_Frames

„ExeThrottle

„FirstBurstLen

„KeepAliveTO

„MAXBurstLen

„MAXOutstandingR2T

„IPv4TOS

„IPv4TTL

Each setting is displayed with the current value in brackets, for example:

FirstBurstLen [256] :

To change the value, type the new value after the prompt. To keep the current value, press ENTER at the prompt. SANsurfer iSCSI HBA CLI displays the next device setting. The settings are displayed one by one, in the order shown in the preceding list.

Table A-1 on page A-1describes these settings.

SN0054621-00 E 4-25