Q-Logic SN0054621-00 E manual Bind Target, Delete Target, Configure Target Parameters

A

4 – Interactive Mode Commands Port Level Info & Operations Menu

TGT_TargetSessID	:	5(*)
TGT_TargetIPAddress	:	10.14.64.154
TGT_Window_Scale_Enable	:	on
TGT_Rx_Window_Scale	:	0
TGT_Tx_Window_Scale	:	2(*)
TGT_TimeStamp_Enable	:	64(*)
TGT_DDB_IPv6	:	off
TGT_IPv6_Address	:	a0e:409a::
TGT_Local_TCP_Port	:	29251(*)
TGT_Type_of_Service	:	0
TGT_Traffic_Class	:	0(*)
TGT_Local_IPv6_Address	:	::(*)
TGT_4022_Deleyed_ACK	:	off
TGT_Redirect_IPAddr	:	10.14.64.154
Values noted with (*) are read only.
Press the Enter key to continue.

For a complete list of target parameters, their aliases, functions, and values, see Appendix C Target Parameters.

Bind Target

(CLI Option -pb)

Select the Bind Target option to persistently bind a specific target to the HBA port by saving it in the HBA flash. Targets that are not persistently bound will not persist across firmware resets or HBA power cycles.

When you select this option, SANsurfer iSCSI HBA CLI lists available targets. At the Enter a Target ID: prompt, type the target ID of the target you want to bind.

Delete Target

Select the Delete Target option to remove a target from the HBA database.

Configure Target Parameters

(CLI Option -tc)

Select the Configure Target Parameters option to configure various target parameters. For a list of target parameters by their configuration names, configuration aliases and possible values, refer to Appendix C Target Parameters.

Each setting is displayed with the current value in brackets, for example:

TGT_DefaultTimeout [120] :

To change the value, type the new value after the prompt. To keep the current value, press ENTER at the prompt. SANsurfer iSCSI HBA CLI automatically displays the next target parameter.

SN0054621-00 E 4-39