Q-Logic SN0054621-00 E manual To set only the local link address, enter the following

A

5– Non-Interactive Mode Commands Non-interactive Commands

To set only the local link address, enter the following:

-netconf6 0 -IPLL fe80::1

To set everything automatically, enter the following:

-netconf6 0 -IPLLA -IPR01A -IPRRA

To disable the IPv4 network, enter the following:

-netconf6 0 -DISN4

To disables the IPv4 and IPv6 networks:

-netconf6 0 -DISN4 DISN6

For information on the interactive version of this command, see “Configure IPv6 Settings (CLI Options -netconf,-netconf6,-isns,-isns6,-ip, and -nc)” on

page 4-27.

-nh

(Configure iSCSI Settings)

To set the HBA level parameters for multiport HBAs, enter the -nhcommand as follows:

-nh<hba_port_inst> <Config name Config alias> <Value> [<<Config name Config alias>> <Value> …]

The valid parameters and their values are shown in Table 5-3. For a complete list of HBA parameters, see Appendix C Target Parameters.

For information on the interactive version of this command, see “Configure iSCSI Settings (CLI Options -n and -nh)” on page 4-24.

-pa

(Add a Target)

To add persistent targets, enter the -pacommand as follows:

-pa <hba_port_inst> <IP Address> [-PORTport number] [-INAMEiSCSI Name]

If you do not specify a port number [-PORTport number], SANsurfer iSCSI HBA CLI uses the default number 3260. If you do not specify an iSCSI name, [-INAMEiSCSI Name] SANsurfer iSCSI HBA CLI uses the default value, an empty string.

For information on the interactive version of this command, see “Add a Target (CLI Option -pa)” on page 4-40.

SN0054621-00 E 5-23