Q-Logic SN0054621-00 E manual Port- and HBA-level Parameters, Port-level Parameters

A Port- and HBA-level Parameters

The tables in this appendix list the following types of SANsurfer iSCSI HBA CLI parameters:

„Port-level Parameters

„HBA-level Parameters (see page A-10)

Port-level Parameters

Table A-1lists the HBA port firmware parameters and their values. To view all parameters, both configurable and non-configurable (read-only), use the -coption in non-interactive mode. To edit configurable parameters, use the -noption in non-interactive mode.

NOTE:

The parameters in this table are sorted alphabetically for ease of use.

Table A-1. Port Settings

Parameter	Value	Alias	Description
AFW_AutoConnect	on, off	AFWC	When on, the HBA will not try to autoconnect to
			the configured targets at boot time. Instead, the
			host must issue Set Device Database Entry
			commands (0063h) to establish connections to
			targets.
AFW_Delayed_Ack	on, off	AFDACK	Determines what occurs when the HBA receives
			a Data-In PDU with the Final bit set and no sta-
			tus reported. When on, the HBA sends a TCP
			acknowledgment immediately (this is the default
			value). When this parameter is off, the HBA
			delays the acknowledgment and waits for more
			data.
AFW_Device_Timeout	on, off	AFWDT	When on, the HBA firmware ignores the IOCB
			command timeout values specified by the host.

SN0054621-00 E A-1