Q-Logic SN0054621-00 E manual Dtrema, Dumpcore, Dumpnvram, Edchap

A

5– Non-Interactive Mode Commands Non-interactive Commands

-dtrema

(Remove Discovered Target)

To remove all non-persistent discovered targets, enter the -dtremacommand as follows:

-dtrema <hba_port_inst>

For information on the interactive version of this command, “Remove Discovered Target” on page 4-46.

-dumpcore

(Retrieve FW Coredump Record)

To dump the RAM memory to a file name of your choice, enter the -dumpcorecommand as follows:

-dumpcore <hba_port_inst> [File name]

For information on the interactive version of this command, see “Retrieve FW Coredump Record (CLI Option -dumpcore)” on page 4-16.

-dumpnvram

(Retrieve FW Flash & NVRAM Record)

To dump the NVRAM to a file name of your choice, enter the -dumpnvramcommand as follows:

-dumpnvram <hba_port_inst> [File name]

For information on the interactive version of this command, “Retrieve FW Flash & NVRAM Record (CLI Option -dumpnvram)” on page 4-15.

-dv

To see the version of the iSCSI HBA driver(s) installed, enter the -dvcommand as follows.

-dv

There is no corresponding command in the interactive menu; however, you can use this interactive option to view the current driver version: “Install HBA Driver, All Adapters (CLI Option -d)” on page 4-11.

-edchap

(Edit a CHAP Entry)

To change the value of the specified CHAP entry, enter the -edchapcommand as follows:

-edchap<hba_port_inst> <CHAP> <Parameter> <Parameter Alias> <Value> [<Parameter> <Parameter Alias> <Value> …]

SN0054621-00 E 5-11