Q-Logic SN0054621-00 E manual Ldrouterauto, Ldra, Loclinkauto, Locla, Routableauto, Rauto

A– Port- and HBA-level Parameters Port-level Parameters

S

Table A-1. Port Settings (Continued)

Parameter	Value	Alias	Description
KeepAliveTO	0–65535	KATO	This parameter indicates the time interval (in
	seconds		seconds) between connection keep-alive pings.
			When a connection is idle for the connection
			keep-alive timeout interval, the HBA sends an
			NOP ping to the other device (target) that is part
			of the connection. When the (target) device
			responds to the ping, the connection remains
			open. If the (target) device fails to respond, the
			HBA closes the connection and informs the
			driver that the connection has gone down. The
			maximum keep-alive time is 18 hours.
Large_Framesa	on, off	LRGFRM	(Not for QLA4010s) Defines the maximum
			Ethernet frame length. On sets for Jumbo (9kB
			max) frames. Off sets frame length to 1.5 KB.
			Determines when to fragment IP datagrams;
			larger frames are discarded.
LDROUTER_AUTO	on, off	LDRA	Local default router. Gets router address auto-
			matically.
LOC_LINK_AUTO	on, off	LOCLA	Local link auto.
MaxBurstLen	0–32767	MBL	Tells max length for data sequences the HBA
	unitsa		uses when negotiating with a target device dur-
			ing login. Tells how many 512 byte units the
			HBA can send/receive. 0 means unlimited data
			units.
MaxOutstandingR2T	1–	MOR2T	Tells maximum number of outstanding R2Ts the
	65535		HBA uses when negotiating during login. Tells
			how many R2Ts can be outstanding on a SCSI
			task.
MaxRxDataSegmentLena	0–	n/a	Tells maximum data segment size (in 512-byte
	65535		units) that the HBA can receive in one PDU.
Porta	0–	n/a	Gives the port number the HBA (as target) lis-
	65535		tens to for iSCSI connections. Ignored when the
			HBA is an initiator only. Default port = 3260.
ROUTABLE_AUTO	on, off	RAUTO	When on, the firmware will auto-configure
			routable addresses from the default router (if
			one is available)

A-8 SN0054621-00 E