Q-Logic SN0054621-00 E manual Port Level Info & Operations Menu, Port Link Settings Menu

A

4 – Interactive Mode Commands Port Level Info & Operations Menu

Port Level Info & Operations Menu

The Port Level Info & Operations Menu provides the following options:

1.Port Link Settings (see page 4-19)

2.Port Network Settings Menu (see page 4-20)

3.Edit Configured Port Settings Menu (see page 4-22)

4.Port Restore Factory Defaults (see page 4-28)

5.Port Diagnostic Menu (see page 4-29)

6.BIOS/UEFI Settings Menu (see page 4-34)

7.---> Target Level Info & Operations (see page 4-36)

8.Select HBA Port (see page 4-49)

9.Refresh (see page 4-49)

10.Exit (see page 4-50)

On each submenu, save the changes by typing the number for the Save changes and reset HBA option, and then pressing ENTER. This saves your changes and resets all ports on the HBA.

To update the firmware with these changes, type the number for the Refresh option, and then press ENTER. If you do not select this option, your changes will not be visible in SANsurfer iSCSI HBA CLI.

Port Link Settings Menu

Select the Port Link Settings Menu option to open the Port Link Configuration Menu containing the following options:

1.Display Active Link Configuration (see page 4-19)

2.Display Configured Link Configuration (see page 4-20)

3.Configure Link Configuration (see page 4-20)

4.Save changes and reset HBA (if necessary) (see page 4-20)

5.Select HBA Port (see page 4-49)

6.Refresh (see page 4-49)

7.Exit (see page 4-50)

Display Active Link Configuration

Select the Display Active Link Configuration option to view the following information about the active link:

Connection type		: (Copper or Fiber)
Portal Duplex		: (Half-duplex,Full-duplex, or Disabled)
Portal Flow	Control	: (on or off)
Portal Link	speed	: (in Mbs)

SN0054621-00 E 4-19