Q-Logic SN0054621-00 E manual Non-interactive Mode Commands

SANsurfer iSCSI HBA CLI User’s Guide

Command Line Interface for QLogic iSCSI Host Bus Adapters

S

	Target Level Info & Operations	4-36
	List Targets (CLI Option -t)	4-37
	Display Target Information (CLI Option -t)	4-37
	Bind Target (CLI Option -pb)	4-39
	Delete Target	4-39
	Configure Target Parameters (CLI Option -tc)	4-39
	Add a Target (CLI Option -pa)	4-40
	Disable a Target	4-40
	Enable a Target	4-40
	Configure Target Authentication Menu	4-40
	Target Discovery Menu	4-44
	List LUN Information (CLI Option -l)	4-47
	Save Target/CHAP Changes (No CLI Option)	4-47
	List All QLogic iSCSI HBA Ports Detected (CLI Option -i)	4-48
	Help (CLI Option -h)	4-49
	Select HBA Port (No CLI Option)	4-49
	Refresh (No CLI Option)	4-49
	Exit (No CLI Option)	4-50
5	Non-interactive Mode Commands
	Non-interactive Commands	5-3
	-acb	5-3
	-addchap (Add a CHAP Entry)	5-3
	-arp (Display ARP Table)	5-3
	-b (HBA Reset)	5-3
	-binfo (Display BIOS/UEFI [or FCode] Information)	5-4
	-bootcode (Update BIOS/UEFI [or FCode] Mode)	5-4
	-bootcodemode (Set BIOS/UEFI [or FCode] Mode)	5-4
	-c (Display Configured Port Settings)	5-5
	-ch (HBA Information)	5-5
	-chapmap (Display Targets Using CHAP Entries)	5-6
	-cpbootcode (Clear Primary Boot Target Information)	5-6
	-csbootcode (Clear Secondary Boot Target Information)	5-6
	-d (Install HBA Driver, All Adapters)	5-6
	-dc(Display Destination Cache [IPv6 only])	5-7
	-dce	5-7
	-defbidi (Add a Default BIDI CHAP)	5-7
	-delchap (Delete a CHAP Entry)	5-7
	-df	5-8
	-dp	5-8

Page viii SN0054621-00 E