5Non-Interactive Mode Commands Non-interactive Commands

S

You can repeat the <Parameter><Parameter Alias> <Value> parameter pair to change multiple values as shown in Table 5-2. Press ENTER after each entry.

Table 5-2. CHAP Parameters

Parameter

Parameter Alias

Value

 

 

 

CHAPName

CNAME

character string

CHAPSecret

CSECRET

character string

 

 

 

CHAPBidi

CBIDI

on or off

 

 

 

Issuing this command resets the HBA. For information on the interactive version of this command, “Edit a CHAP Entry (CLI Option -edchap)” on page 4-43.

-ei)

To get information about errors and exit codes for non-interactive mode, enter the -eicommand as follows (no parameters are required):

-ei

To view a list of non-interactive mode errors, see “Non-interactive Mode Error Codes” on page D-5.

-f

(Update Firmware Image—Specific HBA)

The firmware runs the tasks involved in data management, the iSCSI protocol, and general HBA functioning. Use the -fcommand to update the firmware image. For information on firmware file names, see Appendix E Downloadable File Names.

To update the HBA firmware from a specified file, enter the -fcommand as follows:

-f <hba_port_inst> <file name>

Both parameters are required. The <hba_port_inst> is the HBA to update. The <file name> is the file containing the firmware image to upload to the HBA. Be sure to use full path names. Issuing this command resets the HBA.

For information on the interactive version of this command, see “Update Firmware Image (CLI Option -f)” on page 4-13.

-fa

(Update Firmware Image—All HBAs)

To update the firmware for all HBAs for which the image is appropriate, enter the -facommand as follows:

5-12

SN0054621-00 E

Page 96
Image 96
Q-Logic SN0054621-00 E manual Update Firmware Image-Specific HBA, Update Firmware Image-All HBAs, Chap Parameters