Q-Logic SN0054621-00 E manual Rdh, Port Restore Factory Defaults

A

5– Non-Interactive Mode Commands Non-interactive Commands

-rdh

(Port Restore Factory Defaults)

NOTE:

The -rdhcommand is not supported in the QLA4010 HBA.

Type the following command to restore the specified HBA port’s settings to their factory defaults:

-rdh <hba_port_inst> [A] [F N I T C V]

Where:

hba_port_inst = HBA port whose factory settings you want to restore.

A= Restores the factory settings for the entire HBA (firmware parame- ters, network parameters, iSCSI name, targets, CHAP table, NVARAM, and IPSec).

Issuing this command resets the HBA. If you use this option, no others are necessary.

F= Restores firmware parameters to the factory default values.

Issuing this command resets the HBA.

N= Restores network parameters to the factory default values.

Issuing this command resets the HBA.

I= Restores the iSCSI name to the factory default value.

Issuing this command resets the HBA.

T= Restores the targets to the factory default values.

C= Restores the CHAP table to the factory default values. V = Restores the NVRAM to the factory default values.

If you want to restore all areas of the HBA port, either use the A parameter, or use no parameter. Otherwise, specify which areas to restore. For example, the following command restores the firmware and NVRAM to the factory defaults:

-rdh<hba_port_inst> F N

For information on the interactive version of this command, see “Port Restore Factory Defaults (CLI Option -rdh)” on page 4-28.

SN0054621-00 E 5-27