Q-Logic SN0054621-00 E manual Binfo, Bootcodemode, Update BIOS/UEFI or FCode Mode

5– Non-Interactive Mode Commands Non-interactive Commands

S

NOTES:

„Issuing this command resets both ports (0 and 1) on two-port HBAs.

„You must disable bootcode mode to reset the HBA (see “-bootcodemode (Set BIOS/UEFI [or FCode] Mode)” on page 5-4).

For information on the interactive version of this command “HBA Reset (CLI Option -b)” on page 4-14.

-binfo

(Display BIOS/UEFI [or FCode] Information)

To display the bootcode settings for the specified HBA port, enter the -binfocommand as follows:

-binfo<hba_port_inst>

For information on the interactive version of this command, see “Display BIOS/UEFI [or FCode] Information (CLI Option -binfo)” on page 4-35.

-bootcode

(Update BIOS/UEFI [or FCode] Mode)

Bootcode (that is, the bootable code image) is code that allows system boot from an iSCSI drive.

The -bootcodecommand updates the bootcode code image, which should be done when QLogic releases a new bootcode with bug fixes or enhancements. At the prompt, type the name of the file containing the bootcode code image to upload to the HBA.

For information on bootcode file names, see Appendix E Downloadable File Names.

To update the bootcode code image, enter the -bootcodecommand as follows:

-bootcode<hba_port_inst> <Bootcode Code Image File Name>

For information on the interactive version of this command, see “Update BIOS/UEFI [or FCode] Code Image (CLI Option -bootcode)” on page 4-13.

-bootcodemode

(Set BIOS/UEFI [or FCode] Mode)

To set the bootmode mode for QLA4050, QLA4050C, QLE4060C, QLE4062, and QMC4052 HBAs, enter the -bootcodemodecommand as follows:

-bootcodemode <hba_port_inst> <1><2><3>

5-4 SN0054621-00 E