Q-Logic SN0054621-00 E manual Non-interactive Commands, Acb, Addchap, Arp, HBA Reset

A

5– Non-Interactive Mode Commands Non-interactive Commands

Non-interactive Commands

This section contains an alphabetical list of the SANsurfer iSCSI HBA CLI commands used in non-interactive mode.

-acb

To inquire whether the ACB (access method control block) firmware functions are supported, enter the -acbcommand. In general, up-to-date firmware and driver are required for ACB to be supported.

-addchap

(Add a CHAP Entry)

To add a CHAP entry to the persistent CHAP table, enter the -addchapcommand as follows:

-addchap[-BIDI]<hba_port_inst> <CHAP Name> <CHAP Secret>

The optional parameter [-BIDI]shows that the CHAP entry is BIDI (bidirectional). When this parameter is not specified (default), the CHAP entry is local.

Issuing this command resets the HBA. For more information on CHAP and the interactive version of this command, see “Add a CHAP Entry (CLI Option -addchap)” on page 4-42.

-arp

(Display ARP Table)

The Address Resolution Protocol (ARP) cache keeps a record of host port connections with other hardware (such as targets) on the network. The IP address/MAC address pairs are dynamic entries that are removed after 10 minutes. To view the ARP table, enter the -arpcommand as follows:

-arp<hba_port_inst>

For information on the interactive version of this command, see “Display ARP Table (CLI Option -arp)” on page 4-32.

-b

(HBA Reset)

To reset the specified HBA after making configuration changes, enter the -bcommand as follows:

-b<hba_port_inst>

SN0054621-00 E 5-3