Q-Logic SN0054621-00 E manual Ping, Following provides the IPv6 source address values

A

5– Non-Interactive Mode Commands Non-interactive Commands

-ping

(Ping Target)

To ping the target device specified IP address, enter the -pingcommand as follows:

-ping <hba_port_inst> <IP Address> <Ping Count> <Packet size> <IPv6 source address>

The following provides the IPv6 source address values:

0= Do Not Care

1= Local Link

2= Address 0

3= Address 1

Where:

hba_port_inst	= The HBA port that sends the ping.
IP Address	= The IP address to pin.
Ping Count	= The number of ping packets you want (1–[2^31]).
Packet Size	= The size of the ping packet 0-64kB
IPv6 Source	= Origin device
Address

For information on the interactive version of this command, see “Ping Target (CLI Option -ping)” on page 4-30.

-ps

To view persistent targets for the HBA port, enter the -pscommand as follows:

-ps<hba_port_inst> [Target ID]

If you do not specify the [Target ID], SANsurfer iSCSI HBA CLI displays all targets for the specified HBA port number. If you do not specify the port instance [hba_port_inst] nor the Target ID, [Target ID], SANsurfer iSCSI HBA CLI displays all target IDs for all HBA ports in the system.

There is no interactive command for this function.

-pu

To unbind a persistent target, enter the -pucommand as follows:

-pu<hba_port_inst> <Target ID>

SN0054621-00 E 5-25