Q-Logic SN0054621-00 E manual Chapmap, Cpbootcode, Csbootcode, Install HBA Driver, All Adapters

5– Non-Interactive Mode Commands Non-interactive Commands

S

For a list of HBA settings, see Table 5-3 on page 5-19. For a complete list of HBA parameters, see Appendix C Target Parameters.

For information on the interactive version of this command, see “HBA Information (CLI Option -ch)” on page 4-12.

-chapmap

(Display Targets Using CHAP Entries)

To display the map of targets to CHAP table entries, enter the -chapmapcommand as follows:

-chapmap<hba_port_inst>

For information on the interactive version of this command, see “Display Targets Using CHAP Entries (CLI Option -chapmap)” on page 4-41.

-cpbootcode

(Clear Primary Boot Target Information)

To clear the primary boot target and LUN, enter the -cpbootcodecommand as follows:

-cpbootcode<hba_port_inst>

For information on the interactive version of this command, see “Clear Primary Boot Target Information (CLI Option -cpbootcode)” on page 4-36.

NOTE:

This command is not active for the PPC.

-csbootcode

(Clear Secondary Boot Target Information)

To clear the secondary boot target and LUN, enter the -csbootcodecommand as follows:

-csbootcode<hba_port_inst>

For information on the interactive version of this command, see “Clear Secondary Boot Target Information (CLI Option -csbootcode)” on page 4-36.

-d

(Install HBA Driver, All Adapters)

To install an HBA driver for all iSCSI HBAs on the system from a .zip or .inf file, enter the -dcommand as follows:

-d <File Name>

A system reboot may be required; see the log file for details.

5-6 SN0054621-00 E