Troubleshooting HP-UX IPQoS

Troubleshooting Scenarios

Troubleshooting Scenarios

This section contains information about a few possible troubleshooting scenarios, including symptoms and solutions.

Installation Scenario: HP-UX IPQoS Installation Fails

Problem

HP-UX IPQoS installation fails.

Symptoms

Output from running:

swinstall -x resinstall=true -s /tmp/IPQoS.depot HPUXIPQOS

indicates a failure or problem.

Solution

1.Verify that installation requirements have been met. See “System Requirements” on page 35 for more information.

2.Examine the /var/adm/sw/swinstall.log and /var/adm/sw/swagent.log files for messages indicating what the problem might be. Run swjob. The swjob arguments are typically specified at the end of the swinstall process. The syntax is as follows:

swjob -a log hostname-# @ hostname:/.

3.If any problems are found, correct them and again try to install the software, by running the following command:

swinstall -x resinstall=true -s /tmp/IPQoS.depot HPUXIPQOS

HP-UX IPQoS Configuration File Verification Fails

Problem

HP-UX IPQoS configuration file verification fails.

Symptoms

When you try to verify or load a configuration file, you get error messages.

104

Chapter 6