HP UX IPQos Software 54

Getting Started with HP-UX IPQoS

System Operation

Step 3. Run the following command:

#/sbin/init.d/ipqos_dne stop

NOTE	In HP-UX 11i v1 and HP-UX 11i v2, if you have not completed the
	#/sbin/init.d/ipqos stop step, you will receive a device busy
	message when you run this command. That step must precede
	issuing this command.
	In HP-UX 11i v1, certain applications may have opened the DLPI
	device and not closed it, in which case you get a device busy
	message when you run this command. If this happens, you must
	identify the application and make it close DLPI, or you will need to
	reboot.

Step 4. Restart networking using one or more of the following:

•Run the following command:

#/sbin/init.d/net start

•If using an IPv6-enabled system, run the following command:

#/sbin/init.d/net-ipv6 start

•Manually reconfigure any additional networking setup as needed.

Chapter 3