HP-UX IPQoS Configuration Files

Filter Blocks

•Attributes ending in lo[w] or hi[gh] must have a numerical value specified, a name is not allowed.

•If you specify srcaddrlo and not srcaddrhi, or vice-versa, it is equivalent to specifying both as having the same value. The same is true for dstaddrlo and dstaddrhi, srcportlo and srcporthi, dstportlo and dstporthi. Essentially, this is the same as specifying srcaddr, dstaddr, srcport or dstport.

Address and Port Attributes

Specify addresses and port numbers by using the following keywords and syntax:

srcaddrlo[w] addr

Low end of the source address range.

srcaddrhi[gh] addr

High end of the source address range.

dstaddrlo[w] addr

Low end of the destination address range.

dstaddrhi[gh] addr

High end of the destination address range.

srcaddr addr or hostname

Source address. This is equivalent to specifying the same value for both srcaddrlo and srcaddrhi.

Do not specify this attribute with srcaddrlo or srcaddrhi.

dstaddr addr or hostname

Destination address. This is equivalent to specifying the same value for both dstaddrlo and dstaddrhi.

Do not specify this attribute with dstaddrlo or dstaddrhi.

addr[ess] addr or hostname

Explicitly creates two filters that otherwise have the same attributes. Specify this attribute when you want to filter on an address or name, and you do not need to specify a direction. In one filter, dstaddrlo=dstaddrhi= addr or hostname. In the other filter, srcaddrlo=srcaddrhi= addr or hostname.

Do not specify this attribute with srcaddrlo, srcaddrhi, dstaddrlo or dstaddrhi.

Chapter 4

65