JVC HR-DD840U SET Input Mode, Locate END Point, Reset the Counter, Locate Start Point, EN Editing

52ENEDITING(cont.)

Insert editing replaces part of the recorded scene with new

material. Both the picture and Hi-Fi audio soundtrack are

Insert Editing replaced with new ones, while the normal audio soundtrack remains unchanged. If you wish to change the normal audio

track as well, use the audio dubbing function simultaneously. Use your VCR as the recorder.

Recorder Your VCR Source tape

TIME SCAN SHUTTLE

q

PAUSE JOG

Audio/Video cable (supplied)

Audio/Video signal

Another VCR

Player

1	2	3
4	5	6
7	8	9
C.RESET	0
	NUMBER "0"

PAUSE

	Before insert editing	Normal audio
Recorded tape		track
	After insert editing
		Video/Hi-Fi
		audio track

MAKE CONNECTIONS

1 Connect the player's VIDEO OUT and AUDIO OUT connectors to your VCR's VIDEO IN and AUDIO IN on the front panel.

SET INPUT MODE

2 Press NUMBER key "0". "AU" appears in place of a channel number.

●Be sure to select the correct AUX input connector at the Aux Input screen. (To select the correct AUX input connector, follow steps 4, 5, 9 – 11 from the "Edit From A Camcorder" section ☞ pg. 50).

LOCATE END POINT

3 Load the recording cassette into your VCR, and play it back to determine the edit-out point (the end of the segment to be replaced) using the JOG/TIME SCAN SHUTTLE controls or TIME SCAN ª£ and PAUSE.

4	RESET THE COUNTER
	Press C.RESET to change the counter display to
	"0H00M00S".
5	LOCATE START POINT
	Determine the edit-in point (the beginning of the
	segment to be replaced) using the JOG/TIME SCAN
	SHUTTLE controls or TIME SCAN ª£ and PAUSE.
	● Be sure to engage the Still mode at the edit-in point.

TIME SCAN