JVC HR-DD840U On-Screen, Access Program SET, Select Program Number, Time SCAN, Cancel and Menu

44ENTIMERRECORDING(cont.)

	You can directly program the VCR’s timer to record up to 8
On-Screen
	shows, as far as a year in advance. Remember, the clock must be
	on the remote control light to tell you which button to press next.
	set before you can program the timer (☞ pg. 7 or 9).You can also
Timer	use the optional Illumi-Guide feature, where the relevant buttons
	The Illumi-Guide feature is activated by the ILLUMI GUIDE
	button on the remote control. The Illumi-Guide feature is only
	active when the remote control's TV/CABLE/DBS/VCR switch is
Programming	set to "VCR". (Illumi-Guide is an optional help feature which
	makes programming easier. It is not necessary to use Illumi-Guide
	to program the VCR.)

Turn on the TV and select the VCR channel 3 or 4 (or AV					1	LOAD A CASSETTE
						Make sure the record safety tab is intact. If not, cover
mode).
						the hole with adhesive tape, then load it into the VCR.
						● The VCR comes on, and the counter is reset,
						automatically.
OK						ACCESS ON-SCREEN
				q		MENU
					2
CH						To use the Illumi-Guide feature press ILLUMI GUIDE.
						The MENU, REW, PLAY and FF buttons will light.
MENU						Press MENU as many times as necessary to bring up the
						Main Menu screen.
						● If you are using the Illumi-Guide feature, MENU
	1	2	3
						lights up and OK blinks.
NUMBER	4	5	6			ACCESS PROGRAM SET
NUMBER "8" 7		8	9	NUMBER "9"
				TIMER		SCREEN
		0			3
						Make sure the highlight bar (arrow) is on				"PROGRAM
				CH		SET", then press OK.
						● If you are using the Illumi-Guide feature, OK blinks
						when the following buttons are lit: NUMBER keys (0
				TV/CABLE/DBS/VCR		– 9), TIME SCAN, CANCEL and MENU.
					4	SELECT PROGRAM NUMBER
						Press the appropriate			PROGRAM 1
						NUMBER keys or CH5°or
				OK		TIME SCAN5	°	to select a	DATE	– –/– –
									START	– –:– – AM
MENU						vacant program number,			STOP	– –:– – AM
						then press OK. The first time
									CHANNEL	– – SP
						you set the timer program-
				TIME SCAN					PRESS NUMBER KEY (O–9)
						ming function, all the
						program numbers will be			OR (5,°), THEN (OK)
				ILLUMI GUIDE					PRESS (MENU) TO END
						blank; in this case just press
						OK when the Program Set screen appears.

	● If you are using the Illumi-Guide feature, OK blinks
When Using The Illumi-Guide Feature	when the following buttons are lit: NUMBER keys
	(0 – 9), TIME SCAN, CANCEL and MENU.
● Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.
● If for some reason the remote control's signal is not received
by the VCR, press MENU as many times as necessary to
return to the normal screen and extinguish all
illuminated buttons, and re-perform the timer programming
procedure from the beginning.