JVC HR-DD840U Engage Manual Tracking Mode, Adjust Manual Tracking, RE-ENGAGE Automatic Tracking

26EN

PLAYBACKANDRECORDINGFEATURES(cont.)

Manual Tracking

Once playback begins, the VCR’s automatic tracking function is engaged. If noise appears in the picture, you can override this and make the adjustment manually.

	q
CH	SCAN SHUTTLE	1
	TIME

2

1	2	3
4	5	6	3
7	8	9
	0

CH

ENGAGE MANUAL

TRACKING MODE

During playback, press the CH5 and ° buttons on the VCR's front panel simultaneously to cancel the automatic tracking mode and enable manual tracking adjust.

ADJUST MANUAL

TRACKING

Press CH5 or ° on the VCR's front panel or remote. Press briefly for fine adjust, or press and hold for coarse adjust. Watch the screen and continue adjusting until optimum picture and sound quality are achieved.

RE-ENGAGE AUTOMATIC TRACKING

Press the CH5and ° buttons on the VCR's front panel simultaneously.

●When automatic tracking is re-engaged, Auto Picture is automatically activated.

NOTES:

●To obtain a noiseless still picture it may be necessary to adjust

FFtracking in slow playback and then engage Pause.

REW	● Manual tracking is possible during hands-free slow-motion.
	During hands-free slow-motion playback, simply press CH5
	or ° on the VCR's front panel or remote to adjust tracking.

Tape Position Indicator

The Tape position indicator appears
on screen when, from the stop
mode, you press FF, REW, or use
the TIME SCAN SHUTTLE ring, or
perform an Index Search or Instant
ReView. The position of "	" in	B	+	+	+		E
relation to "B" (Beginning) or "E"				COUNT		0:33:27
(End) shows you where you are on
the tape.

NOTES:

●"SUPERIMPOSE" must be set to "ON", or the indicator will not appear (☞ pg. 28).

●It may take a few seconds for the Tape Position Indicator to be displayed.