JVC HR-DD840U Re-perform the VCR Plus+ setup Doesn’t work properly, When scanning channels, some

							E	N	61
8.	Satellite channels are not automati-		● The Controller is not properly		Connect the Controller correctly
	cally switched during timer		connected to the VCR.		(☞ pg. 20).
	recording.		● The output channel selected in the		After confirming your DBS receiver’s
			DBS Receiver Output screen is		output channel number, re-access the
			incorrect.		DBS Receiver Output screen and
			● The VCR is not set correctly to		select the correct number (☞ pg. 21).
					Set the correct DBS Receiver brand
			control the DBS Receiver		code (☞ pg. 22).
			● The DBS receiver’s power is off.		Make sure the power is on before
					timer recording starts.
9.	Timer recording begins as sched-		● Even though you don't use an		Set "CABLE BOX OUTPUT" to "OFF"
	uled, but the channel is always		external Cable Box, "CABLE BOX		(☞ pg. 16).
	incorrect.		OUTPUT" is set to "ON".
10.We moved, and now VCR Plus+			● The receivable stations in the new area		Re-perform the VCR Plus+ setup
	doesn’t work properly.		are received on different channels than		procedure (☞ pg. 18).
			those in the previous area.
11.	“PROGRAM FULL” is displayed on		● All 8 programs of the VCR’s timer		Wait until a space in memory clears,
	the VCR Plus+ screen.		memory are used.		or cancel unnecessary program
					information (☞ pg. 46).
OTHER PROBLEMS
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	When scanning channels, some of		● Those channels have been preset to		If you need the skipped channels,
	them are skipped over.		be skipped.		restore them (☞ pg. 14).
2.	The channel can’t be changed.		● Recording is in progress.		Press PAUSE to pause the recording,
					change channels, then press PLAY to
					resume recording.
3.	The remote control won’t operate		● The TV/CABLE/DBS/VCR switch is		Set the switch to the correct position.
	my TV or cable box or DBS receiver.		set to the wrong position.		Re-set the remote control to the
			● The remote control brand setting is
			incorrect.		correct brand (☞ pg. 55 or 56 or 57).
4.	Even though Auto or Semi-Auto		● The clock setting data received from		Select a different Host Channel during
	clock setting has been selected, the		the Host Channel is incorrect.		the Semi-Auto setting procedure
	clock is incorrect.				(☞ pg. 10), or perform the Manual
					setting procedure (☞ pg. 11).

ATTENTION:

This VCR contains microcomputers. External electronic noise or interference can cause microcomputer to malfunction. If the VCR does not operate correctly switch its power off and unplug the power cord from the AC supply. Wait for a while and then plug the power back in. Eject and check the condition of the cassette. If everything appears normal resume operating the VCR as usual.