19
Notes:
• H-POSITION, V-POSITION, CLOCK and PHASE will
change depending on the input signal.
Normally, these parameters need not to be set.
In case the position of the picture is still shifted even
AUTO TUNING button is pressed, operate base on the
procedure below.
1. Set the left edge of the picture to the left edge of the
monitor screen while adjusting H-POSITION.
2. Set the right edge of the picture to the right edge of the
monitor screen while adjusting CLOCK.
3. Repeat steps 2 and 3 until the position of the picture is
on the center of the screen.
• OSD H-POSITION and OSD V-POSITION settings can-
not be reset.
• Adjustment parameters from PC are not supported.
CONNECTING WITH WJ-HD300 SERIES
• There is a possibility that the picture will be shifted if the
Monitor (VGA) terminal of the Digital Disk Recorder WJ-
HD300 series is connected to the PC input even AUTO
button is pressed. In this case, adjust H-POSITION
and CLOCK following the procedure indicated in upper
left note.
Picture-in-Picture Mode Monitoring
The input signal of subscreen displays on the upper right of
display panel.
2. After displaying the subscreen, pressing the POS button will
move the subscreen as shown below.
7. After setting the parameters, press the MENU button.
Set values will be stored and the Video Adjustment Menu will
exit.
Caution:
• If power is cut off setting, it will not store the settings
that have changed.
3. Press the INPUT SELECT button in selecting Video, S-Video,
or Component input that appears on the subscreen when PC
input is currently on the main screen.
VIDEO
1. Press the PIP button to display the subscreen in approxi-
mately 2 seconds waiting time, as shown below.
• PC Input is displayed in subscreen when Composite Video,
S-Video or Component Video inputs is displayed on main
screen of the monitor.
• VIDEO, S-VIDEO or COMPONENT is displayed in subscreen
depending on the last input done prior to switching to PC Input
when PC input is displayed on main screen of the monitor.
34
21