Panasonic WVCP304

CP310

CP300

AUTO: Similar to the basic functions of AUTO1, but does not change the IR filter.

Switches to black-and-white images when brightness (illuminance) around the

camera is lower than approx. 0.1 lx.

OFF (default): Displays color images.

Note:

 •

CP310

CP300

When “AUTO1” or “AUTO2” is selected, it is recommended to set “AGC” to “ON”.

 • If a subject is always moving or the screen is occupied with a uniform color,brightness

determination may not be performed successfully because the brightness is merely deter-

minedby information from the CCD image sensor.When "AUTO2" is selected, the wave

length of the light source shall be 800 nm or longer.

 • WV-CP300andWV-CP304cannotset theswitching brightness(illuminance)level ofcolor

images and black-and-white images.

 • Toobtaincolorimages,asufficientlevelofilluminance(approx.30lxormore)isrequired.

Step 2

Pressthe[SET]button.

→ The "D&N (IR)" screen appears.

Step 3

Movethecursorto"LEVEL"andselectabrightnesslevelatwhichswitchingbetweencolorand

black-and-white images is performed from the following.

LOW: Switches from color to black-and-white images when the ambient brightness (illumi-

nance) of the camera is less than 0.1 lx.

HIGH (default): Switches from color to black-and-white images when the ambient brightness

(illuminance) of the camera is less than 0.2 lx.

Note:

 • Theswitchingilluminancelevelvarieswithsubjects,lightsources,andlenses.

 • TheswitchingilluminancelevelvariesinaccordancewithAGCsetting.( page 12)

 •The switching illuminances described  above arereference values. The switching illumi-

nanceshallbedecidedbasedontheactualinstallationenvironment.

 • Theremay be repeated switching between color and black-and-white images depending

onthesettingandenvironment.

Step 4

Movethe cursor to "DURATIONTIME" and select a time for switching between color and

black-and-white images from the following.

2S-10S(default)-30S-60S

(S)

(L)

Step 5

Movethecursorto "BURST(BW)",anddecide whetherornotto provideaburstsignaloutput

in the black-and-white mode.

ON (default): Providesaburstsignaloutput.

OFF: Doesnotprovideanyburstsignaloutput.

CP310

CP300

CP310

CP300

CP310

CP300

CP310

CP300