ParaBody 894104A manual Step

STEP 8

Wrapthe 94-1/2" CABLE(9) around one 3-1/2" PULLEY(8) and SECURELYassemble the PULLEYto the PULLEY BRACKET(5) using one 3/8 X 2" BOLT(14) and one LOCKNUT(18) as shown in FIGURE

FIGURE 8

FIGURE 9

STEP9:

¯Insert each end of the 94-1/2" CABLE(9) into the bushings on the cams of the LEFT(2) & RIGHT(3) PECARMS,then the CABLEover the PULLEYSassembled to the CENTEt~PULLEYBRACKET(4) as shown in FIGtYRE

¯After CABLE(9) has been routed over the PULLEYSon the CENTEKPULLEYBRACKET(4), position CABLERETAINING CLIPS(13) at a ° angle ov er th e PULLEYS and SECURELY ghtenti. Se e FI GUPd3 9(NOTE:. If C.. ~BLE (9)is n ot trac king

in the center of the cams on the LEFT(2) & RIGHT(3) PECARMS,Loosen BEARINGHOUSI~IG(1) and adjust then retighten.)