Safety Information
Operating Instructions
Troubleshooting Tips
About the display diagnostic codes.
Display | What It Means | What To Do |
| Not enough water is | Unlatch the door. If there is no water in |
| entering the dishwasher. | the bottom of the dishwasher, check the |
|
| water supply to the dishwasher. |
¥ Is the dishwasher water supply turned on?
| OR | ¥ Is the household water supply turned on? | ||
|
| ¥ If you use well or cistern water, is the | ||
|
| supply adequate? | ||
|
| If the water supply is adequate, try the | ||
|
| cycle again. If | repeats, call for service. | |
|
|
| ||
| The drain pump could be | Unlatch the door. If there is standing | ||
| temporarily blocked | water in the bottom of the dishwasher, | ||
| (usually caused by food | relatch the door, touch START, then | ||
| particles such as cereal). | immediately touch RESET to start the | ||
|
| pump. If | continues to appear, you | |
|
| may need to do this several times to | ||
|
| break up the blockage. | ||
|
|
| ||
| The water temperature | Avoid showers or laundry just prior to | ||
| in the dishwasher did not | running the dishwasher. (Use the | ||
| reach the proper wash | DELAY START feature to start dishwasher | ||
| temperature. This is | when the water heater is up to normal | ||
| usually caused by lack of | temperature.) Adjust household | ||
| hot water coming from the | water heater thermostat to 120°F. | ||
| household water heater. | minimum. |
| |
|
| If | appears with every cycle and you |
know the water from the water heater is hot (120°F. or more), call for service.
The temperature sensor in the dishwasher is not functioning properly.
Dishwasher may continue to be used, but it will not heat water automatically.
The temperature sensor needs to be replaced. Call for service.
NOTE: You may continue to use your dishwasher. For best results adjust your household water heater thermostat to 140°F.
Customer Service
Before You Call For Service
■Try the cycle again to see if the code reappears. The dishwasher may correct itself.
■Electronic controls can be affected by outside interference. Shutting off power to the dishwasher (at the fuse or circuit breaker) could correct the problem. Restore power after 15 seconds and try the cycle again.
| ■ Check the guide for things you can do to correct the problem. |
14 | ■ See the Troubleshooting Tips at the back of this manual. |