GE GSD4435, GSD4930 Options, Start, Safety Information, Operating Instructions, Load Selection

Models: GSD4920 GSD4910 GSD4940 GSD4420 GSD4425 GSD4430 GSD4410 GSD4930 GSD4435

1 28
Download 28 pages 59.94 Kb
Page 9
Image 9
Load Selection

2

Load Selection

 

NORMAL For loads of everyday dishes, glasses and cookware with medium soils. NOTE: Many dishes have lighter soil than normal. Choosing a cycle other than NORMAL will save energy and water.

POTS PANS For heavily soiled dishes or cookware with dried-on or baked-on soils. Everyday dishes may be included. This cycle will not remove burned-on foods.

CHINA CRYSTAL For lightly soiled china and crystal. Water is aerated for a gentle wash.

RINSE HOLD For rinsing partial loads that will be washed later. Make sure ENERGY SAVER DRY is selected. Do not use detergent or DELAY START with this cycle.

3 Options

ENERGY SAVER Shuts off the drying heat options. Dishes air dry naturally DRY ON and energy is saved. You can prop the door open after the

word CLEAN appears in the display.

ENERGY SAVER Turns the drying heater on for fast drying. This cycle will DRY OFF extend the time to your wash cycle.

DELAY START You can delay the start of a wash cycle for up to 14 hours. Tap or press and hold the DELAY START pad to choose the number of hours you want to delay the start of the cycle. The machine will count down and start automatically at the correct time. NOTE: If you forget to latch the door a reminder signal will beep until you do so.

RESET To change a cycle after washing starts, touch the RESET pad to cancel cycle. After water is pumped out and motor stops, you can reprogram and restart the dishwasher.

LOCK When the LOCK pad is touched twice within 3 seconds, all pads become inoperative. You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle or selected DELAY START so the cycle or DELAY START is not interrupted. The word LOCKED appears in the display.

Children cannot accidentally start dishwasher by touching pads.

To unlock the dishwasher after it has been locked, touch the LOCK pad twice within 3 seconds. The word LOCKED will disappear from the display.

4 Start

Latch the door and touch the START pad to begin the cycle. There is a time delay between start-up and water fill so you will not hear any wash action right away.

Safety Information

Operating Instructions

Troubleshooting Tips

Customer Service

9

Page 9
Image 9
GE GSD4435, GSD4930 Options, Start, Safety Information, Operating Instructions, Troubleshooting Tips Customer Service