GE GSD4430 About the display diagnostic codes, China Crystal cycle, close, NORMAL, Pots Pans or

Safety Information

Operating Instructions

Troubleshooting Tips

Customer Service

About the display diagnostic codes.

Display	What It Means	What To Do
	Electrical power to the	IF DISHWASHER WAS IN USE WHEN
	dishwasher has been	THE POWER FAILURE OCCURRED:
RESET	interrupted but is now	1 Press the RESET pad and wait
	back on.
		approximately 30 seconds.
		2 Unlatch and open the door.
		A	If the detergent cup is open and
			empty and the dishwasher was set
			for the NORMAL, POTS PANS or
			CHINA CRYSTAL cycle, close
			door and put the load through a
			RINSE HOLD cycle. After the
			RINSE HOLD cycle is completed,
			add detergent and reset the load
			for the washing cycle you want.
		B	If the detergent cup is closed and
			the dishwasher was set for the
			NORMAL, POTS PANS or
			CHINA CRYSTAL cycle, reset the
			dishwasher for the wash cycle
			you want.
		C	If the dishwasher was set for the
			RINSE HOLD cycle, reset the
			dishwasher for RINSE HOLD.
		IF THE DISHWASHER WAS NOT IN USE
		when power failure occurred, use
		dishwasher as you normally would.
	Slow draining. The	This dishwasher is designed to
	dishwasher is taking	automatically compensate for longer
	longer than normal to	than normal drain times, but cycle time
	drain the water out.	will be extended. If this code continues
	This is usually caused	to appear frequently:
	by a blockage in the drain	1 Clean the air gap.
	air gap, a kink in the
		2 Check for a kink in the drain hose.
	drain hose, or a
	stopped-up pipe.	3 Check plumbing for slow or
		stopped-up drains.

NOTE: Warranty service does not cover household drain problems.

12